12
Assembly - Attaching the Fan Blades (continued)
Fastening the blade assemblies to
the motor
2
□
Fasten the blade/blade bracket assembly to the fan motor
assembly (E) by inserting the alignment post into the slot on
the bottom of the motor and tightening the pre-installed blade
bracket screws (OO) by inserting a screw driver through the
access hole (ZZ).
□
Repeat this step for the remaining blade assemblies by rotating
the motor until the next blade bracket screw can be accessed
through the access hole (ZZ) in the switch cup.
Assembly - Attaching the Lights
Attaching the light kit fitter assembly
1
□
Remove the three screws (VV) on the switch cup cover of the
light kit fitter assembly (F).
□
Connect the wires from the light kit fitter assembly (F) to the
wires from the switch cup of the fan-motor assembly (E) by
connecting the molded adaptor plugs together (blue to black,
white to white). Carefully tuck all wires and splices into the
switch cup.
□
Align the three holes in the switch cup cover of the light kit
fitter assembly (F) with the three holes in the switch cup of the
fan-motor assembly (E). Make sure the notch in the switch cup
cover of the light kit fitter assembly (F) clears the reversing
switch in the switch cup of the fan-motor assembly (E). Position
the light kit fitter assembly (F) and re-install the three screws
(VV) that were removed in first step to secure the light kit fitter
assembly (F).
CAUTION:
To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light fixture.
NOTE:
Notice the location of the fan’s slide switch. This is the
switch used to change the fan’s directional rotation. For more
information on the operation of this switch, see
Operating
Your Fan
on page 14.
IMPORTANT:
The switch cup has an access hole (ZZ) to
allow the screwdriver to reach the screws in the blade
bracket. Position the blade bracket on the motor and
tighten by inserting the screwdriver through the access
hole (ZZ).
WARNING:
Remove the rubber motor stops on the bottom
of the fan before installing the blades or testing the motor.
ZZ
E
H
OO
VV
F
E
