M
O
C
.
Y
A
B
N
O
T
P
M
A
H
7
.
e
c
n
a
t
s
i
s
s
a
r
e
h
t
r
u
f
r
o
f
3
1
3
0
-
7
2
5
-
7
7
8
-
1
t
c
a
t
n
o
c
e
s
a
e
l
P
Assembly – Standard Ceiling Mounting
1
Preparing for mounting
2
Routing the wires
Ƒ
Remove the canopy ring from the canopy (C) by turning the
ring to the right until it unlocks.
Ƒ
Remove the mounting bracket (A) from the canopy by
loosening the four screws on the top of the canopy (C).
Ƒ
Remove the two non-slotted screws, and loosen the slotted
screws. This will enable you to remove the mounting
bracket (A).
Ƒ
Route the wires exiting the top of the fan motor (D) into the
decorative motor collar cover (F) and through the canopy
ring (C).
Ƒ
Make sure the slot openings are on top and route the wires
through the canopy (C) and then through the ball/downrod
assembly (B).
3
Assembling the fan
Ƒ
Loosen, but do not remove, the setsrew (GG) on the collar
on top of the motor housing (D).
Ƒ
Align the holes at the bottom of the downrod (B) with the
holes in the collar on top of the motor housing (D).
Ƒ
Carefully insert the hanger pin (CC) through the holes in the
collar and downrod (B). Be careful not to jam the hanger
pin (CC) against the wiring inside the downrod (B).
Ƒ
Insert the locking pin (DD) through the hole near the end of
the hanger pin (CC) until it snaps into its locked position.
Ƒ
Re-tighten the setscrews on the collar on top of the
motor housing (D).
WARNING:
Failure to properly install the locking pin could
result in the fan becoming loose and possibly falling.
C
A
C
D
F
B
B
D
F
CC
DD
B
GG
