6
Assembly
1
Attaching the upper leg and
lower leg
2
Attaching the leg connector
bracket and legs
□ Position upper and lower legs (B & C) in a cross-x
pattern. Connect the legs in the center.
□ Place the table base face down on a soft, flat
surface. Attach the leg connector bracket (D) to
table legs (B & C) by inserting four hex bolts (BB)
and metal washers (CC).
NOTE:
Do not tighten bolts until all parts are
attached on the underside of the table frame.
NOTE:
Each bolt should be tightened a few
revolutions at a time, alternating between bolts in a
cross corner (X) pattern, to ensure your table is level.
Drain hole
