HAMPTON BAY Edgemont 324-848, Owner'S Manual

4

Figure 6

Motor Wires

Ball/Downrod 
Assembly

Ceiling Canopy

Canopy Bottom 
Cover

Pin in Locked 
Positioon

Motor Collar

Coupling Cover

Tighten Screw 
Firmly

REMEMBER

 to  turn off the power. Follow the 

steps below to hang your fan properly.

Hanging the Fan

Remove the decorative canopy bottom cover 
from the canopy by turning the cover counter 
clockwise. (Figure 5)

Remove the mounting bracket from the canopy 
by removing the 1 of 2 screws from the bottom
of the mounting bracket and loosening the 
other one a half turn from the screw head. 
Next, turn the canopy counter clockwise to 
removing the canopy cover form the canopy. 
(Figure 4)

Remove the clevis pin, cotter pin and set 
screws from the top of the motor assembly. 
(Figure 6)

NOTE:

 If a longer downrod is needed, take out 

the screw located in the hanger ball, lower the 
hanger ball and remove the pin, remove all 3 
pieces from the downrod and assemble them 
onto the new longer downrod before 
proceeding step 4. (The longer downrod is 
available at any Home Depot store)

Route wires exiting from the top of the fan 
motor through the coupling cover, canopy 
cover, canopy and then through the ball/ 
downrod. (Figure 6)

1.

2.

3.

4.

WARNING

FAILURE TO PROPERLY INSTALL COTTER PIN 

AS NOTED IN STEP 5 COULD RESULT IN FAN 

LOOSENING AND POSSIBLY FALLING.

Tighten two set screws at top of the fan motor 
collar firmly and evenly. (Fig. 6)

6.

Cotter Pin

Clevis Pin

Align the holes at the bottom of the downrod 
with the holes in the coupling on top of the 
motor housing (Figure 6). Carefully insert the 
clevis pin through the holes in the collar and 
downrod. Be careful not to jam the clevis pin 
against the wiring inside the downrod. Insert 
the cotter pin through the hole near the end of 
the clevis pin until it snaps into its locked 
position, as noted in the circle inset of Fig. 6.

5.

Figure 5

Ceiling
Mounting
Bracket

Ceiling Canopy

Canopy Bottom
Cover