7 HAMPTONBAY.com
Please contact 1-855-HD-HAMPTON for further assistance.
Operation
1
Setting the Sensor for Testing
When the “ON-TIME” switch is set to the “TEST”
position, the light fixture will operate during the day
or night. The light will stay on for 5 seconds after all
motion is stopped.
□
Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
□
Set the “ON-TIME” switch to the “TEST”
position.
□
Set the “SENS” switch to the “MIN” position.
NOTE:
The motion sensor will need to completely warm
up (90 seconds) before beginning the setup process.
ON-TIME
TEST 1 5 10
SENS
MIN MAX
2
Adjusting the Motion Sensor
Detection Zone
□
Perform a “walk test”. Walk in an arc across
the front of the motion sensor (2).
□
Watch the light. The light will come on when
motion has been detected.
□
Stop, wait for the light to turn off, and then
begin walking again.
□
Continue this process until the detection zone
has been established.
□
Adjust the motion sensor (2) up and down or
rotate the light fixture (A) top side to side to
change the motion sensor (2) detection zone.
3
Adjusting the SENS Switch
□
To increase the detection zone, slide the
“SENS” switch toward the “MAX” position.
□
To decrease the detection zone, slide the
“SENS” switch toward the “MIN” position.
NOTE:
The motion sensor is more sensitive to motion
moving across the front of the sensor. The motion sensor
is less sensitive to motion moving directly toward the front
of the sensor.
NOTE:
The higher the “SENS” setting (sensitivity), the
greater the possibility of false triggering. To reduce false
triggering, slide the “SENS” switch toward the “MIN”
setting.
ON-TIME
TEST 1 5 10
SENS
MIN MAX
2
A
B
