9
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTON for further assistance.
Operation (continued)
5
Setting the TIME ON/OFF
6
Using the TEST function
This setting allows you to control the time the lights turn on and
when they will go off.
a) Press MENU until the TIME ON/OFF LED indicator is lit and press
OK. The digit display shows "ON".
b) When the AM and PM LED begin to flash, press the UP or DOWN
arrow button to select AM or PM and press OK.
c) When the Hour begins to flash, press the UP or DOWN arrow to
desired hour and press OK.
d) When the Minute begins to flash, press the UP or DOWN arrow to
desired Minute and press OK.
e) The display shows "OFF" indicating that you can now set the OFF
time.
f) When AM and PM begins to flash, press the UP or DOWN arrow
button to select AM or PM and press OK.
g) When the Hour begins to flash, press the UP or DOWN arrow to
desired hour and press OK.
h) When the Minute begins to flash, press the UP or DOWN arrow to
desired Minute and press OK.
This setting allows you to test your landscape lighting after
installation.
Press MENU until the TEST LED indicator is lit and press OK.
The time of photocell feeling the external light signal: the lights will
turn on at dusk and off at dawn within 0.5 seconds.
NOTE: When using the TEST function during
daylight hours with the photocell installed on the
transformer, be sure to completely cover the
photocell for the lights to turn on. The photocell
needs to sense darkness in order to function, even
in TEST mode. If no photocell is installed on the
transformer, the lights will turn on regardless of
daylight when using the TEST function.
NOTE: If you do not press "OK", the transformer
defaults enter into the presently-set function
within 10 seconds. In other modes outside of
TEST, the transformer defaults enter into the
presently -set function within 30 seconds.
7
Power outage
8
Display Auto Shut-down
In the event of a power outage the transformer functions may need
to be reset.
In TEST mode, the display and LED indicator lights on the transformer
turn off after approximately 10 seconds of idle time. In all other
modes, this auto shutdown occurs after approximately 120 seconds.
Press any button to turn on the transformer display.
9
Restoring the Factory Settings
To restore the transformer to its original factory settings, press and
hold the OK button for 3 seconds. The display shows 88:88 and
resets to 12:00 after 1 second to indicate that the transformer is now
restored to factory settings.
