9.
Place the glass shade over the light holder and secure it with
the screws provided. (Fig. 16)
Installing the light bulb & glass shade
WARNING:
Shut off the power supply before removing or
replacing lamp.
1.Connect the wire connector from the fan to the lamp, then
install the lamp (22W) to the light plate using the 3 lamp
holders to prop up the lamp. Be sure to pull the lamp holders
out a little for installing the lamp easier. (Fig.16)
2.
Figure 16
NOTE:
Light bulb have no warranty, can be purchased at local light
bulb specialty store or from our service center.
Screws
Light holder
Lamp
Lamp
holder
Wire
connector
Glass shade
