7
HAMPTONBAY.COM
Please contact 1-855-HD-HAMPTONBAY for further assistance.
Assembly - Standard Ceiling Mount
Routing the wires
Assembling the fan
Preparing for standard mounting
□
Align the holes at the bottom of the ball/downrod assembly (B)
with the holes in the collar on top of the fan-motor assembly (E).
□
Carefully insert the hanger pin (DD) through the holes in the
collar and ball/downrod assembly (B). Be careful not to jam
the hanger pin (DD) against the wiring inside the ball/downrod
assembly (B).
□
Insert the locking pin (EE) through the hole near the end of the
hanger pin (DD) until it snaps into its locked position.
□
Re-tighten the setscrews (LL) on the collar on top of the
fanmotor assembly (E).
□
Pull off the canopy bottom cover (JJ) from the canopy
□
Loosen the two canopy screws (HH) located on the bottom of the
mounting bracket (A), and turn the canopy counterclockwise
to remove the mounting bracket (A) from the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the decorative motor collar cover (D) and then the
center of the canopy bottom cover (JJ).
□
Make sure the opening of the canopy (C) is on top and insert
the ball/downrod (B) through the canopy (C).
□
Route the wires exiting the top of the fan motor assembly (E)
through the downrod as shown.
2
3
1
NOTE:
This fan is equipped with a safety tab. Should the
setscrew (LL) ever become loose while the fan is running
in reverse, the safety tab will engage and stop the fan from
falling.
NOTE:
The magnet is pre-attached on the canopy bottom
cover for you to remove and install easily.
A
C
JJ
II
C
D
E
JJ
B
EE
DD
C
D
E
JJ
B
LL
PP
