10
Assembly - Attaching the Fan Blades
Attaching the fan blades
5
□
Attach blade (F) to blade bracket (G) using the screws (AA)
provided. Please note that the rubber washers are pre-
attached to the blade bracket (G). Insert a screw into the
blade bracket (G). Repeat for the two remaining screws (AA).
□
Tighten each screw securely.
□
Fasten the blade assembly to the motor by inserting the
alignment post into the slot on the bottom of the motor and
tighten the motor screws. Please note that the motor screws
are pre-attached into the blade arm.
□
Repeat steps 1-3 for the remaining blades.
AA
F
G
Mounting the fan
Close-to-Ceiling mounting
□
Align the locking slots of the ceiling canopy (C) with the two
screws in the mounting bracket (A). Push up to engage the
slots, and turn clockwise to lock the canopy (C) in place.
□
Firmly tighten the two mounting screws (WW).
□
Install the remaining two mounting screws (WW) into the
holes in the canopy (C) and tighten firmly.
4
WARNING:
When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
D
C
A
WW
WARNING:
The locking slots of the ceiling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattended
until all four canopy screws are engaged and firmly tightened.
D
C
A
WW
□
Carefully unhook the fan from the mounting bracket (A) and
align the locking slots of the ceiling canopy (C) with the two
screws in the mounting bracket (A). Push up to engage the
slots and turn clockwise to lock the canopy (C) in place.
Immediately tighten the two mounting screws (WW) firmly.
□
Install the remaining two mounting screws (WW) into the
holes in the canopy (C) and tighten firmly.
Assembly - Hanging the Fan (continued)
NOTE:
Your fan blades are reversible. Select the blade
side finish which best accentuates you decor.
