EZMaster
EZMaster
User’s Guide
Page 29 of 53
Extended TAB
The extended TAB shows the Standard commands plus the Extended functions that are supported in this mode.
Here you can:
1.
Configure the routing of the radio’s data, allowing for example to choose RADIOA data to USB port and RADIOB to COM, or
RADIOA to COM and RADIOB to USB.
2.
PLAYing and RECording all the 7 voice messages available in EZMaster.
3.
Redefine the standard four messages played from those applications that support only 4 messages.
4.
Define flags to tuning the EZMaster configuration, for particular applications or settings.
5.
Defining the Matrix Profile if selected in the Matrix Mode radio button.
6.
Selecting the output of the Antenna Relay Switch:
Replicate
Data are replicated from Parallel Port to Antenna Matrix A output
Decode
Data from Parallel Port are decoded and Pin 1-10 of the Antenna Matrix A is the decoded output.
Matrix
An user defined profile is used and Antenna Matrix A pins reflect this profile to each band, for any RX
and/or TX status.
Grayed out commands, including Profiles, can be sent to EZMaster only after checking the “Setting” radio button in the Command
frame. “SETTING MODE” will be shown on the EZMaster Display, and gray buttons will become available. After setting your
configuration select the “Run” radio button, in the Command frame, to switch back EZMaster in the Extended Mode.
