EN
24
Constant
Starting
Press the power switch, press in the self-locking
button, then release the power switch.
Switching off
Pressing the power switch and then release.
FIG. 2
SPEED CONTROL
This polishing machine has an electronic
control device that maintains the required
constant speed regardless of the pressure. The
speed is set with the small knob on the top of
the handle (1). The knob is marked in steps of
1, 2, 3, 4, 5 and 6. For maximum power set the
knob to 6.
FIG. 3
POLISHING
1. Fit the polishing bonnet.
2. Apply polish evenly all over the surface of
the bonnet.
3. Hold the bonnet against the surface to be
polished and start the machine.
4. Move the polishing machine smoothly
over the surface. Do not press.
5. Always switch off the machine before
lifting it up from the surface being
polished.
6. Polish the car to a bright surface finish in
the same way and same order as when
applying the polish.
7. Remove the layer of polish in the same
order as when applying the polish.
NOTE:
Do not press the polishing machine.
in actual operating conditions (taking into
account all stages of the work cycle, e.g. the
time when the tool is switched off and when
it is idling, in addition to the start-up time).
DESCRIPTION
1. Speed control
2. Self-locking button
3. Power switch
4. Brush cap
5. Polishing disc
6. Front handle
FIG. 1
ASSEMBLY
FASTENING THE POLISHING
BONNET
The polishing machine is supplied with a
medium/hard polishing bonnet. The polishing
bonnet is used to apply polish and for
polishing. The bonnet must be fastened firmly
and form a flat surface on the polishing disc.
USE
Hold the polishing machine in a firm grip with
both hands when polishing (one hand on the
handle with the power switch and the other on
the front handle).
POWER SWITCH
Starting
Press the power switch.
Switching off
Release the power switch.
Summary of Contents for 004229
Page 4: ...1 2 1 3 2 4 5 1 6...