Hamron 008377, Operating Instructions Manual

EN

22

3.   Set the required pressure (see section 

"Automatic pressure monitor").

     FIG.   5

4.  Activate the automatic pressure monitor 

and press the power switch. The 
compressor switches off automatically 
when the set pressure is reached. Switch 
off the compressor switch afterwards.

ACCESSORY NOZZLES

1.   Screw on the required accessory nozzle 

(conical nozzle or needle nozzle) on the 
air hose connection. Tighten until the 
connection is airtight.

     FIG.   6

2.   Put the accessory nozzle in the air 

connection in the object to be filled.

     NOTE:   
Extension nozzle, conical standard nozzle and 
needle nozzle supplied.

VOLTAGE SWITCH

The voltage switch is on the back of the 
product. The switch must be in the correct 
position to use the power supply, "AC" for 
mains voltage and "DC" for battery voltage.

     FIG.   7

Mains power (230 V)

Always pull out the full length of the power 
cord before use. Plug the plug in a power point 
and press the switch button marked AC to start 
the product. To switch off the product, press the 
switch button marked DC until the button clicks 
back 1 step to position 0.

8.  Mains power (AC)
9.  Switched off
10.  Battery power (DC)
11.  Mains connection

     FIG.   1

1.  Plug for 230 VAC
2.   Air  hose
3.   Venting  valve
4.   Extension  nozzle
5.   Needle  nozzle
6.   Plug for 12 VDC

     FIG.   2

USE

AUTOMATIC PRESSURE MONITOR

First set the voltage switch to AC for mains 
power, or to DC for battery power in the 
vehicle.
1.   Press the (+) or (–) button for about 5 

seconds, until the display starts flashing. 
Set the required pressure with the (+) 
or (–) button and then wait for 3 to 4 
seconds. The display stops flashing and 
shows the set pressure to which the tyre 
will be filled.

2.   Press the power switch to start the 

compressor. When the set pressure is 
reached the compressor switches off and 
OFF is shown in the display.

INFLATING TYRES

1.   Screw the hose connection on the tyre 

valve.

     FIG.   3

2.   Put the plug in the 12 V outlet in the 

vehicle.

     FIG.   4