Hamron 009028, Operating Instructions Manual

EN

12

MAINTENANCE

•  Remove the batteries when the product is 

not in use.

•  Wipe the spout clean of contaminants 

and debris every week.

3.  Immerse the suction pipe’s inlet (1) below 

the surface of the liquid in the tank from 
which pumping is to take place, then 
insert the outlet hose (2) down into the 
tank (3) that is to be filled.

     FIG.   4

4.  Press the power switch.

 Turn off the pump 

with the power switch before the tank is 
overfilled.

     WARNING!   
The product must not be used for liquids 
hotter than 60°C.
     IMPORTANT:   

•  Do not allow the product to run dry.  

Do not start the product until the suction 
tube’s inlet is below the surface of the 
liquid.

•  Do not use the product for thinner or 

solvents.

•  Do not use the product for hot water.
•  Do not use the product for strong 

solvents or corrosive chemicals, such as 
acetone, benzene, cresol, ethanol, 
phenol, 1-methylethyl, concentrated 
sodium hydroxide, nitric acid, 
hydrochloric acid, sulphuric acid.

•  Do not run the product upside-down 

after use.

•  Remove the batteries when the product 

is not in use.

•  Only use the product in a cool and well 

ventilated environment.

LOW LIQUID FLOW

A low liquid flow may be due to the batteries 
being discharged, in which case you should 
change the batteries, or to the liquid level 
in the storage tank being too low. Top up if 
necessary.