SE
49
EN
STEP 2. FITTING THE RooF
assemble all parts of the roof as per fig. D. use screws (17) and nuts (18). insert the screws in the
holes from the outside in, so that the nuts are on the inside of the tent.
TIP:
lightly tap the screws with a hammer to push them slightly further into the holes. tighten the
nyloc nuts to the point where the screw heads are sunk flush. if the screw heads stick out at all, they
may damage the canvas.
STEP 3. ASSEmBLING THE EDGES oF THE RooF (FIG. E)
Gently tap on the pieces with a rubber mallet to ensure they are correctly assembled.
fig. D
fig. e
