HAMWORTHY HEATING LTD
11
SPETISBURY
500001118/C
Figure 10.3 – Rear Section and Cradle
Figure 10.4 – Fitting Mastic Seal
a.
Position rear section
(Item 4) onto end of cradle
(Item 1) (Fig. 10.3) ensuring
that it is safely supported.
Sections can be lifted by
utilising suitably tested and
protected straps through the
ports or flueways.
IT IS MOST IMPORTANT
THAT THE BACK EDGES OF
THE FEET ON THE
CASTING ARE FLUSH WITH
THE REAR OF THE CRADLE
TO ALLOW FOR CORRECT
FITTING OF THE CASING.
b.
Fit sealing mastic to
grooves around both
perimeter of section and
combustion chamber (Fig.
10.4). Should mastic rope
break during this operation,
the two ends
MUST
be
overlapped to avoid any
leakage.
N.B.
Particular care should
be taken in placing a mastic
seal around both ports to
protect the 'O'-ring gaskets.
