![background image](http://html1.mh-extra.com/html/han-bond/hb-series/hb-series_user-manualline_3483091042.webp)
www.han-bond.com
41
【F4】
not enabled
【F5】
not enabled
【F6】
not enabled
【
】 — draw back
【
】 — go forward
【
】 — left shift
【
】 — right shift
【复位/RESET】
— not enabled
【取消/CANCEL】
— Cancel the current print job, in the standby state can
enter the test option the current print job.Cancel
1.Test X axis motor;
2.Drawing test;
3.Test cutting;
4.Test ink jet。
【气泵/FAN 】
— press it to start pump, press it again is to stop
【 】
— during the machine working , press the switch, to suspend work,
click it again is to run; in settings state, press it to save parameters; enter the
settings item 13, press and hold it for 3 seconds can restore factory settings (be
care operating this function).
【设置/SETUP】
— press [set /SETUP] into the set state, through 【
】 、
【
】to rolling parameters settings, by【
】、
【
】to carry out parameter
value’s increase and decrease, press the 【 】save parameters and exit.
Summary of Contents for HB Series
