www.han-bond.com
21
Warm tip:
if at work, a cartridge ink has run out, you do not have to buy a new
cartridge, then Han-bond ink jet cutting machine can switch into a single jet
mode (one cartridge work), that’s through the operation panel set 17 of the
[nozzle selection : left / right / all ] options to change into a single injection
mode.
3.6.5 cleaning cartridge
If the printing graphics have some points or lines not printed (see Figure 10),
you need cleaning cartridge.
Fig. 10 comparison of drawing effect
Figure 11 clean electronic contact
Figure 12 clean electronic ink cartridge PCB
Manual washing
A clean the electronic contacts in the cartridge holder with a dry swab (see
Figure 11).
Summary of Contents for HB Series
