Dolphin® 7900 Series User’s Guide
Rev D
7 - 15
Connections Tab
The Connections tab enables you to manage your network connections.
Icon
Tapping this icon…
Beam
Enables you to verify and adjust the infrared settings of the IrDA port; see
Using Infrared
on page
8-5.
.
Connections
Enables you to configure network connections.
This is the connections manager; see
Connections Tab
on page
7-15.
.
Network Cards
Enables you to access the Wireless and Network Adapters tabs; see
Network Cards
on page
7-24.
.
Radio Manager
Enables you to power up and power down the radios installed on the terminal;
see
Radio Manager
on page
4-5.
Other Icons on the Connections Tab
Other icons appear on this window if your terminal is configured with specific network software, protocols, and/or radios.
802.11b Settings
This icon appears
only
if an 802.11b radio and driver is installed on the terminal.
Tapping this icon enables you to configure your 802.11b radio; see
Wireless LAN (WLAN)
Communications with 802.11b
on page
9-1.
IrDA
This icon appears
only
if a Bluetooth radio and driver is installed on the terminal.
Tapping this icon enables you to disable or enable the IrDA port; see
Verify That the IrDA Port is
Enabled
on page
8-5.
.
uPhone GPRS
This icon appears
only
if a GSM/GPRS radio and driver are installed on the terminal.
Tapping this icon opens the GPRS settings; see
GPRS Settings
on page
11-22.
.
Server-Assigned IP Addresses
Please note that all server-assigned IP addresses use Dynamic Host Configuration Protocol (DHCP).
Zero-Config Wi-Fi
Please note that the zero-config Wi-Fi feature of Windows Mobile is
disabled
on Dolphin 7900 terminals.
Com Port Assignment Table
The Dolphin 7900 terminal ships with the com ports assigned as follows:
Com
Port
Assignment
1
Serial port; this is the 17-pin connector on the bottom panel.
See
Mechanical Connector
on page
3-9.
2
Bluetooth Module
If there is no Bluetooth hardware installed on the terminal, this com port is unassigned.
Downloaded from
www.Manualslib.com
manuals search engine
