EN-3
Step 1. Connect the Power and USB Communication Cables
Use only IK8560/70 power cables and power adapters. Use of peripherals, cables, or
power adapters not sold/manufactured by Hand Held Products will void the warranty and
may damage the device.
To run, the IK8560/70 must be connected to an external power source at all
times.
Note: Make sure the power switch is turned off on the workstation where you
are installing the IK8560/70.
1. Plug the 15-pin
connector (HDB15)
on the cable into the
DB15 connector on
the back of the
IK8560/70.
2. Plug the USB
connector into the
port on your host
workstation.
3. Plug the power plug
into the pod on the
communication
cable.
4. Plug the AC power
supply into a power
outlet.
Hardware installation is now complete. Your IK8560/70 powers on and auto-
configures to USB.
Note: These instructions specify the USB communication cable (p/n 42206398-
01E). For information about additional cables, consult the Image Kiosk
8560/8570 User’s Guide.
Step 2. Boot the Device
1. The IK8560/70 begins booting as soon as power is applied from the cable.
2. The splash screen appears as the system cold boots. The software version
numbers for both the bootloader and the kernel appear on the splash screen.
3. The device begins loading software; this is Autoinstall. A status bar appears
for each program that loads. Do NOT interrupt Autoinstall!
4. Autoinstall completes and the splash screen appears again as the system
warm boots.
!
2
4
3
1
Ho
s
t
