4–1
Cordless System Manual
Introduction
Use this section to program parameters for application work groups for the
Cordless System.
This programming section contains the following menu selections:
•
Output Selections (User Feedback)
•
Prefix and Suffix
Section 4
Application Work Groups Menu
•
Data Formatter
The Application Work Groups Selection (on the next page) sets up the
application work group(s). After you’ve scanned the association bar code on the
Base, scan one of the work group numbers to assign the Cordless Scanner to
a specific group. You may then program whatever parameters your application
requires from the Output (User Feedback), Prefix and Suffix, and Data Formatter
Selections menu pages.
Application work groups may be set up in different configurations using the
programming selections found in this section of the manual. For example, one
group may need the beeper turned off, will only scan Code 39 bar codes, and
needs a carriage return suffix added to the data being sent to the host system
via the Base. Another group may require that scanner voting be turned on, will
scan UPC A, and needs a space added to the transmitted data, between the main
UPC bar code data and the five digit addenda.
When you set up and connect the Cordless System to your host system, you
associate the Cordless Scanner to its Base unit. If you are using more than one
Cordless Scanner, you may also set up application work groups. (Instructions
for associating more scanners – up to nine – to the Base are on page 1–7.)
To add a new Cordless Scanner to an established group, associate the scanner
to the Base and scan the application work group number. The scanner will
operate and send data to the host system according to that group’s programmed
selections. Any programming selections you change or make with one Cordless
Scanner will affect all the scanners in a work group.
Note: To program a group’s parameters, you must first scan the group number
and then the programming selections (prefix, suffix, data formatter, etc.). The
parameters can’t be programmed first and then “made” a group by scanning an
application work group number.
To remove a scanner associated with a Base unit, use the Remove Scanner
Selection on page 4–3. For instance, if nine scanners are associated with a
Base (the maximum number) and you want to add a new scanner, you will need
to remove one scanner from the established work groups. After removing one
scanner by using the Remove Scanner programming bar code, add the new
scanner by scanning the association bar code on the Base unit.
Summary of Contents for SCANTEAM 2070 BASE
