info@handandeyestudio.co.uk
handandeyestudio.co.uk
©Oc
tober 2022
Lighting for all the senses.
Isla EU/UK
Assembly Instructions 1/2
1. Ceramic shade
2. Ceramic backplate
3. LED assembly
4. LED lenses and edge cap
5. LED fixing block
6. Wago electrical connectors
7. Heavy duty plasterboard fixings
8. Brass bolt
(low voltage driver - see diagram 3)
Diagram 1
Lamp components & assembly
1
Steps
The Isla wall light comes pre-assembled for safe transit
with parts 1,2,3,4 & 5 pre assembled. To install the lamp
follow the below steps carefully.
1
Install the external driver
The lamp requires a driver to provide the low voltage
power supply to the integrated LEDs.
We recommend installing the driver in an accessible
location such as a cupboard or services room.
Connect the mains side of the driver to the mains power
and run suitable cables from the driver to the location of
the wall light.
For full information on the maximum distance possible
between driver and LED please contact the driver
manufacturer. As a guide, most of the drivers that we
supply can be located up to 20m (65 foot) away from the
wall light using a mimimum cable section of 0.5mm2 or
further (potentially up to 50m) if 1mm2 cable is used.
See diagram 3 for electrical wiring diagram
Note!
•
A qualified electrician MUST be used to connect
the wall light to the mains power.
•
Always ensure the mains power is turned OFF
when installing the lamp.
•
These LED modules are low voltage LEDs that
require a remote driver of maximum 350mA
2 Locate wall fixings
The lamp is supplied with 2 heavy duty plasterboard
fixings (7). Locate the desired lamp location and mark
the two fixing holes located at the top and bottom of the
ceramic back plate.
Note!
•
This dimension should be 85mm but as the lamp
is ceramic there can be minor variations. We
recommend offering up the ceramic back plate to
check.
Drill two 7mm holes and insert the heavy duty rawplugs.
Thread in the bolt and tighten into the rawplug
without
the ceramic lightshade attached. This will secure the
rawplug to the back of the plasterboard.
Remove the bolt from the rawplug.
https://www.rawlplug.co.uk/product/sm-interset/
2
3
4
5
6
7
7
Diagram 2
Rawplug Interset Diagram
8
