Page 10
HQ Avanté User Manual
The laser stylus projects a straight laser beam visible
as a dot on surfaces it hits. The laser dot is used as
a guide or stylus, allowing you to stitch the same
pattern onto a quilt that is being traced with the laser
dot.
Laser Operation and Use
There is not a separate on/off switch for the laser.
Power is supplied to the laser when it is plugged into
the HQ Avanté . Be sure the laser is attached to the
HQ Avanté and pointed downward toward the table
before connecting it to the port. Never point it in a
direction that would project the beam into someone’s
eyes. If the laser should cease to operate, check to
ensure the plug is firmly seated into the HQ
18
Avanté
laser port.
CAUTION: Use of controls or adjustments or
performance of procedures other than those specified
herein may result in hazardous radiation exposure.
Laser Focus/Laser Image Size
This high quality laser is focusable. The laser is
focused by simply grasping the threaded housing
surrounding the lens and turning clockwise or
counter-clockwise (see Figure 10). The laser image
can be adjusted bigger or smaller. The direction of
rotation needed is determined by the distance of
the laser from the intended focal plane. Experiment
by turning the threaded end to achieve your desired
focal size.
Clamp Adjustment
The laser attaches to a mounting post. The post may
be vertical or horizontal. The clamp is designed to
articulate in any direction by rotating the clamp on
the post and pivoting the laser up or down. To make
an adjustment, simply loosen the black thumbscrews,
position, and retighten.
Location of Laser Labels
The label is attached to the case of the laser and
contains an arrow which indicates the direction the
laser light will shine when energized. The label must
remain in place on the laser. Removal of the label will
void the laser’s warranty.
Laser Stylus Safety and Use Guidelines
Figure 10
