HQ Pro-Stitcher User Manual
07/23/12
3.8 Installation Instructions
Figure 3.13
Setting Up the New Carriage
1. With the HQ Pro-Stitcher carriage set properly
on the frame system, untie the black twist ties
that are binding the black cables in a loop. Drape
the black cables over the back of the carriage as
shown in
Figure 3.13
.
2. Plug one branch of the new “Y” power cord
(Page 3, I) into the power supply located toward
the rear of the carriage
(
Figure 3.14
)
. Route the
power cord as shown in
Figure 3.13
.
3. With the X-axis engagement lever shifted into
the lowest position, verify that the white gear at
the front of the carriage fully engages with the
blue rack that was previously installed.
a. If the white gear fails to lower enough with the
front disengagement lever in its lowest position,
you will need to adjust the black X-axis lever
bracket to allow the X-axis engagement lever
to drop a little lower. To do this, loosen the
two 4mm Allen bolts and pivot the bracket
downward until the white gear is pressing
firmly on the blue rack, then re-tighten the two
bolts
(
Figure 3.15
)
.
b. Move the carriage along the length of the table
to double-check the placement of the blue rack.
Make adjustments to the blue rack as necessary.
Figure 3.14
Figure 3.15
Adjust only
if necessary
Plug
