HQ Pro-Stitcher User Manual
07/23/12
3.20 Installation Instructions
Figure 3.37
Y-Rack Installation
1. Carefully lay the quilting machine on its power
pod side. Underneath the base plates, near the
wheels on the C-Pod side of the machine
(the side
with the thread tensioner and guides)
there will
be either two screws or two holes. If the screws
are there, use a large slotted
(flat)
screwdriver to
remove the screws
(see
Figure 3.37
)
.
2. Attach the Y-Rack as shown in
Figure 3.38.
The
blue rack should be toward the middle of the
machine while the bolt holes should be toward
the outside. Use the screws that were removed
from the front and rear base plates
(or use the two
smallest screws in the Base Plate Repair Kit (Page
3.16, D) if your machine had no screws here)
to
mount the Y-Rack to the bottom of the front and
rear base plates.
Be careful not to over-tighten the screws as
the base plate holes will strip easily. In case of
accidentally cross-threading or stripping one of
the base plate holes, an emergency repair kit
(D)
has been provided.
3. If the screws in the base plates do not have slotted
heads and you cannot fit a nut driver over the
screw head, please use one of the provided slotted
screws as a replacement
(D)
and use a slotted
screwdriver to tighten the screws in place.
Figure 3.38
Y-Rack
Y-Encoder
