24
PRESSER BAR HEIGHT
1. To check the presser bar
height lift the presser bar
lifter up. Take the gauge and
place it underneath the foot.
The presser foot should rest
on the fourth step which is
6mm.
2. If it is not correct locate the
hex screw that is on the
presser bar block. Take the
2.5 hex driver and insert it
through the front set plate
and the arm thread guide and
into the block. Loosen the
screw and hold it into position
and move it carefully to the
correct height. Do not rotate
the presser bar or the foot will
be out of alignment with the
needle plate.
QM39401