3.
Turn the hand wheel until the thread cutter is at its far swing (to the left). At this
point
T
he
tip
of the thread cutter should be 2
– 2.5 mm from the center needle
position
which you can gauge through the thread guide.
2 - 2.5mm
4. If you need to adjust the
position of the thread cutter
locate the 7mm nut, loosen it
and move the cutter link to
make the thread cutter
swing 2
– 2.5mm. Then
tighten the nut.
40
THREAD CUTTER ADJUSTMENT
(2 of 2)