AUTO TENSION RELEASE
1.Lower the presser foot. Turn the
hand wheel toward you to raise
the needle bar until the needle
point is just above the needle
plate.
2. Set the tension dial to 4 and push
the solenoid disk to the right.
3. The tension disks should
open .5
– 1.0mm.
4. If you need to make an adjustment locate
the 8mm lock nuts (8mm wrench QM40235
from the regular HQ Retailer tool kit) on the
cable. Loosen the lock nut on the right and turn
the adjusting nut on the left.
If the gap is too wide turn the adjusting nut on
the left counterclockwise.
If the gap is too narrow turn the adjusting nut
on the left clockwise.
48