Automatic Thread Cutter Removal,
Adjustments, and Installation
(3 of 4)
5
4
7.
If you continue to have issues with the
thread cutter, such as cutter errors, the thread
cutter unit will need to be replaced.
Remove the Phillips screw and wire clip.
8.
Follow the wires along the bottom of the
machine and cut all of the zip ties that hold the
wires to the machine then unplug the
connector from the A board.
When reinstalling, carefully route the wires
properly and tie them down in the correct spots
with zip ties.
9.
When reinstalling the thread cutter unit to
the step motor, insert the screws into the holes
of the cutter then insert the silver supporting
posts onto the screws.