1.
Carefully hook your finger under
the loop of the brown flexible cable
and pull upward. Do not grab the
cream-colored connector, as this is
soldered to the board.
2.
Unplug the four sets of wires on the
upper-right side of the board. On all
wires excluding the flexible cable in step
#1, ideally grasp the connector and not
the wires to avoid cable damage.
Alternatively grasp the cable set. Never
pull on one single wire.
5
9
Printed Circuit Board A Removal
3.
Locate and remove the three Phillips
screws that hold the A board to the front
panel; then remove the board.