DC Motor Removal and Installation
1.
Slide the motor belt off of the hand
wheel.
2.
Unplug the DC motor wire from the
back of the A board. It is the plug with
the wires wrapped in clear tubing at the
bottom of the ‘A’ board.
3.
Locate and remove the two Phillips
screws that hold the motor to the
machine. Carefully remove the motor.
4.
Replace the motor and motor belt.
The motor belt should have 5mm
deflection with about 200 grams of
pressure while pushing in the middle of
the belt.
5mm
deflection
6
3