HQ Sixteen
™
User Manual 1.6
Page 5
2.
Place the machine on the carriage.
3.
Plug the Ribbon cable into the Front Encoder Assembly. The ribbon cable has a red
colored wire which goes on top.
4.
The remaining length of cable comes back under the machine from the Rear Encoder
Assembly, in front of the rear base, up and over the rear base, under the protruding
display pod and connects into the 9 pin serial port of the machine (see Photo 3).
5.
REMEMBER
that if the machine is to be removed from the carriage, the cable must be
disconnected from the Front Encoder Assembly on the carriage. The other two
connectors on the cable should remain in place. Failure to unplug the cable when
removing the machine from the carriage could result in damage to the cable, encoders,
and carriage.
Photo 3
Summary of Contents for HQSixteen
Page 24: ...www HandiQuilter com ...