HQ Sixteen
™
User Manual 1.6
Page 6
Installing Optional Front Handles
Caution:
Unplug the HQ Sixteen™ from the electrical
outlet
.
All power to the machine must be turned off when
installing the front handles. Failure to do so can result in
damage to the machine.
Important note: Care must be taken to not pinch the
ribbon cable under the handle bar when it is tightened
to the machine.
Locate the two longest bolts and the
appropriate Hex wrench. To install the handles, tilt the
screen forward. Line up the two holes on top of the handles
with the pre-drilled holes on top of the machine. Slide a bolt
into each hole until it stops. Hand tighten, and then use the
Hex wrench to securely fasten the handlebars to the
machine (see Photo 4).
Once both bolts are in place, plug the ribbon connector into
the serial port on the back casing of the machine (see diagram B, #19). Make sure the pins
are lined up so they are not damaged when the plug is pushed in. Push the plug securely
in place.
Installing Optional Rear Handles
Check that the HQ Sixteen™ is unplugged from the electrical outlet. All power to the
machine must be turned off when installing the back handles. Failure to do so can result in
damage to the machine.
The rear handle bar comes mounted with three screws to the “L” bracket. Line up the two
holes in the “L” bracket with those on the rear of the machine. Slide the short bolts into
holes until they stop. Hand tighten, and then use the Hex wrench to securely fasten the
handle to the back of the machine.
Once the two bolts are in place, plug the ribbon connector into the serial port underneath
the rear handle (see diagram C, #33). Ensure the pins are lined up so they are not
damaged when the plug is pushed in. Push the plug securely in place.
Note:
After the handles have been completely installed and plugged in, test them by turning the HQ Sixteen
™
on/off switch to “on”. The handlebars will run a self-test by briefly displaying their version during boot up and
then the LED lights on the front handles will illuminate. After the boot up is completed, all three LCD displays
(side, front handle and rear handle) will display the same menu. If nothing is displayed or if the lights don’t
illuminate, check that the handle bar cable on the side of the machine is plugged in securely, that your machine
is turned on, and that the power cord is plugged into the machine as well as a power source.
Photo 4
Summary of Contents for HQSixteen
Page 24: ...www HandiQuilter com ...