HQ Infi nity User Manual
| 2 5
3. Tighten the nut using the 5mm hex wrench.
Slide the laser clamp onto the mounti ng post
and ti ghten the two knobs on opposite sides of
the clamp.
4 . Plug the cable end into the laser stylus port
on the back of the machine. Wrap the excess
cable around the rear handlebars, or insert it
into the Handi Accessory Rail and use the
T-slot clip to secure.
The laser projects a straight laser beam visible as a dot on surfaces it hits. The laser dot is used as a guide
or stylus enabling you to use printed pantograph designs and sti tch the conti nuous patt ern onto a quilt by
tracing the design with the laser dot.
ONLINE: For more informati on about quilti ng with pantographs, watch the video Using Pantographs
at: htt p://www.handiquilter.com/videos/hq-infi nity/238/.
The laser att aches to a mounti ng post which att aches to the accessory track along the right side of the
machine. The laser stylus can move in any directi on by rotati ng the clamp on the post and pivoti ng the
laser up or down. To make an adjustment, simply loosen the black thumbscrews, positi on, and reti ghten.
Â
IMPORTANT: A label is att ached to the laser’s case and contains an arrow which indicates the
directi on the laser light will shine when energized. The label must remain in place on the laser.
Removing the label voids the laser’s warranty.
Laser Operati on and Safety
Turn the laser on and off using the machine setti ng opti on to turn on or off the laser lights. For more
informati on about turning on and off the laser, see To turn the lasers on or off i n t h e Toolbar Opti ons
secti on of this manual.
Be sure the laser is att ached to the machine and pointed downward toward the table before connecti ng
it to the port. Never point it in a directi on that would project the beam into someone’s eyes. If the laser
should stop working, ensure the plug is fi rmly seated into the Infi nity laser port.
Laser stylus port
