Figure 36
Figure 38
Figure 37
14
HANDICARE 2000 SIMPLICITY / STYLE INSTALLATION MANUAL
Power pack and footplate
Powered (motor) footplate
a
Remove the footrest assembly from the
footrest kit box. Loosen the screw and
remove the shaft from this assembly.
b
Feed the footplate loom and spring around
the back of the motor
(Figure 36)
.
c
Attach the footrest to the power pack
(Figure 37)
.
Note:
Lubricate the three pivot points and
shaft with HTEP grease (food safe grease).
d
Attach the spring to the main chassis
bracket
(Figure 38)
.
e
Attach the connector
(Figure 39)
.
6
Fit the batteries (footplate accessories kit)
(Figure 40)
.
7
Connect the dummy seat toggle looms:
a
Driving toggle 8 way connector (Part No.
181001.50083) and conversion loom
(SIM22900) – seat, direction, key switch
and swivel (can only be fitted one way)
(Figure 41)
.
b
2.5mm battery link (Part No.
181001.52036) across the flying battery
leads – red link wire
(Figure 42)
.
Note:
Ensure that this connection is not
earthed as it will blow a fuse.
8
Taking care not to damage the charge
contacts, drive the power pack on to the
track using the driving toggle.
Note:
Ensure that the top and bottom trunnions
are correctly engaged to the corresponding
teeth on the top and bottom track
(Figure 43)
.
Note:
If the power pack is loaded without
corresponding engagement of the top and
bottom trunnions; and the power pack is
operated it will cause permanent damage to
the power pack.
Figure 44
shows how an
incorrectly loaded power pack will appear.
If this occurs a new power pack MUST
be ordered as a matter of safety.
