Figure 93
Figure 94
Figure 95
30
HANDICARE 2000 SIMPLICITY / STYLE INSTALLATION MANUAL
Electrical connections Style seat (powered)
Electrical connections
Style seat (powered)
Items required:
Tools required:
• None
• None
1
You now have five seat cables to connect
to the chassis
(Figure 93)
.
2
Starting with the motor connector, connect
to the in-line PCB. Make sure the flat surface
of the connector is facing the outer edge of
the PCB
(Figure 94)
.
3
Gently push the motor loom connector into
the in-line PCB
(Figure 95)
.
4
Connect the motor loom earth to the chassis
earth stud
(Figure 96)
.
5
Connect the manual swivel over-ride loom
to the motor loom (4 x Green 5)
(Figure 97)
.
6
Connect the manual swivel over-ride loom
earth to the chassis earth stud
(Figure 98)
.
7
Seat Loom 1. Connect earth to chassis earth
stud and secure with nut
(Figure 99)
.
8
Make seat and footplate electrical connections:
a
Connect the power switch (2 x red).
b
Connect the diagnostic display
(red, black and yellow).
c
Connect the key switch loom from the
power pack (orange and green) to the
swivel switch loom connector (2 x white).
(Figure 100)
.
d
Connect the seat to the swivel switch loom
connector (white)
(Figure 101)
.
e
Connect the toggle loom (orange, blue and
green)
(Figure 102)
.
f
Connect the infra-red receivers on the left
and right sides of the pack (blue sleeved).
