13
A
A
A
MB3195-GB
Figure 19
Adjusting the wheelchair
Adjusting the brakes
Figure 19
To move the brakes, undo the screw
(19A) located on the inside of the frame
at the front of the chair. Move the entire
brake assembly along the track to the
desired position. The correct distance
between the brake block and the wheel
is about 2.5 cm.
It should not normally be necessary to
adjust the brakes from the position in
which they are delivered.
Adjusting the length of the leg
supports
Figure 21
To adjust the length of the leg-rest,
unscrew the screws (21A), adjust
to the desired length, then replace the
screws and tighten.
Figure 21
Figure 20
Adjusting the anti-tip stabiliser
Figure 20
You should adjust the anti-tip stabiliser
when you have changed the centre of
gravity of the chair.
• Undo the screws (20A). Push or pull
the anti-tip stabiliser to the correct
position
• There should be a maximum of 25 mm
from the end of the anti-tip stabiliser to
the floor
• Retighten the screws
Summary of Contents for Exigo 10
