Adjustments options
20
Version 2015v1
2.6.1
Adjusting the angle of the footplate
•
See fig. 010506010.
The angle of the footplate can be adjusted with respect to the
lower leg in steps of 5°.
The angle of the footplate should be adjusted as follows:
•
Loosen locking nut (A) with a large screwdriver.
•
Then loosen the Allen bolt (B) on the inside of the footplate
(C), with an Allen key with a key width of 6 mm, so far that
the teeth of the hinge come completely free. Now the
footplate can be freely adjusted.
•
Adjust the desired angle of the footplate and push the
hinge manually together again.
•
Tighten the Allen bolt securely.
•
Lock the Allen bolt with the locking nut.
XXXXXX-010506010.en.doc
2.6.2
Adjusting the depth of the footplate
•
See fig. 010506020.
The depth of the footplate can be adjusted in two different
positions. For this the left and right footplate should be
exchanged.
The exchanging of the footplates should be done as follows.
•
Remove the calf strap. See 'Removing calf strap'.
•
Loosen the set bolt (A) a few turns with an Allen key with a
key width of 4 mm.
•
Let the footrest (B) lower together with the profile (C) from
the top tube (D).
•
Exchange both footplates for each other and slide them
into the top tubes.
•
Adjust the footplates to the desired height.
•
Tighten the setscrews.
•
If necessary readjust the angle of the footplate, see
'footplate angle adjustment'.
XXXXXX-010506020.en.doc
2.7
Adjusting the armrest
•
See fig. 010508000.
The armrests provide support to the arms to limit the burden
on the shoulders. For this purpose the armrests can be
adjusted in terms of height (A) and depth (B).
The armrests can also be removed (C), to make space to
leave the wheelchair sideways, for example if you make a
transfer from a car seat.
By removing the armrests the wheelchair can be made
smaller, which and it simplifies transport.
SADKIB-010508000.nl.doc
C
A
B
A
C
B
D
C
A
B
