Maintenance
Version 2015v1
35
3.7.3
Adjusting the brake 12”
•
See fig. 020716010.
The brakes should be adjusted as follows:
•
Loosen nut (A) with a spanner with a key width of 10 mm.
•
Loosen the Allen bolt (B) using an Allen key with a key
width of 5 mm to adjust the brake:
•
screwing it upward: brake tighter
•
screwing it downward: brake looser.
•
Tighten the nut (A) again.
SADKIB-020716010-nl.doc
3.7.4
Adjusting the brake 24”
•
See fig. 020716020.
The brakes (for hand or foot operation) should be adjusted as
follows:
•
Loosen nut (A) with a spanner with a key width of 10 mm.
•
Flip the lock clip (B) off the fork (C).
•
Pull the locking pin, which is attached to the lock clip, from
the fork.
•
Tighten or loosen the fork a number of turns, as needed.
•
Push the lock pin into the fork, so that it connects up to the
brake again.
•
Tighten the nut (A) again.
SADKIB-020716020-nl.doc
B
A
B
C
A