Handicare SystemRoMedic Vega505EE, Service Manual

13

S E R V I C E   M A N U A L

Changing spare parts

80100001, 80100002 Front/rear castor 100 mm

Using an Allen key, remove the screw that holds the castor in place. Replace the castor, apply Loctite 2701 or similar, 
and then secure the castor with the screw.

80100045, -46, -47, -48, -52, -59, -60, -61

Connect the charger cable to the control box, and then plug it into a wall socket.

80100051 Control box CBJH

Activate the emergency stop, and then disconnect the actuator and hand control. Remove the two long screws and 
remove the control box.  Install the new control box and secure it with the two crews. Connect the actuator and control 
box.

80100055, 80100056 Actuator leg spreading

Connect the motor cable to the actuator.
Run the actuator until the legs are drawn in fully. Activate emergency stop. Disconnect the actuator from the control box. 
Loosen and remove the screw that holds the actuator to the leg.  Remove the screw covers and loosen the screw and 
nut. Remove the actuator. 
Install the new actuator; start by securing the end that is secured to the leg. Use the accompanying lock nut, and then 
secure the end that is connected to the base of the mobile lift. Use the accompanying lock nut. Replace the screw  
covers. Connect the actuator to the control box.

80100057 Battery CBJ

Remove the lift battery and remove the screws. Disconnect the battery contacts and remove the batteries. Install the 
new batteries in the battery box and connect the contacts. Place the cover on the box and secure it with the screws. 
Note! The battery must be charged for at least 4 hours before it is used for the first time.

80100058 Slingbar lock for slingbar alu

Remove the screws on either side of the safety latch and remove it. Install the new safety latch and secure it with the two 
accompanying M5x12 screws. Position the safety latch, so that the bevelled side is facing in towards the lift hook.

80100062 Hand control 4-button Linak CBJH

Activate the emergency stop, and then disconnect the hand control. Connect the new hand control.

80100065 Front castor 75 mm
80100066 Rear castor 75 mm

Using an Allen key, remove the screw. Replace the castor, securing it with the screw and accompanying lock nut.

80100068 Hanger Strap lock, for steel slingbar

Remove the safety latch by pulling the ring until one side of it is freed from the slingbar, and then remove the other side. 
Insert the new safety latch into the hole on one side of the slingbar, and then into the other hole. Ensure that the safety 
latch snaps securely into place; it must be able to move freely in the holes.

80100074 Bumper kit

Remove the castors and remove the bumper. Install the new bumper and castors.