11
5. Testing
The circuits should be tested as follows:
•
Use the electrical diagram to see which circuit you need to test
•
Disconnect the Handicare Xclusive from the power supply
•
Connect the molex testing link to the pcb
•
Set the multimeter to the “beep” or resistance or voltage test mode
•
Remove the correct connector from the board
•
Push the measuring pins into the back of the connector (see photo).
•
Check that you are testing between the correct connector pins/numbers.
•
No “beep” or resistance means that the circuit being tested is not complete.
If there is a short circuit with the frame, hold one of the measuring pins against the
unit’s ground pin of the seat and push the other measuring pins into the back of the
connector.
Molex testing link
