12
6.
Display
On the lift is a display which shows a diagnostic code to help you locate the cause of
the breakdown. The codes can be found in the user- and installation manual. See
also chapter 15.
7.
The toggle
The lift is operated by the toggle on the armrest. The toggle or the button for the
powered footrest raiser can be swapped from right to left on side.
The lift will not ride when the armrests are in the folded position. It does however
operate on the remotes. During the ride the diagnostic display show “8” or “9”.
An installation toggle loom can be used to ride the power pack without chair.
In case of a public building when the key switch should switch off the toggle but the
remotes should stay operational, the key switch needs to be transferred from the
safety line to the control line.
8.
The remotes
The remotes function on infrared and they need to be fixed to the walls adjacent to
the stairlift. On the backside is a dipswitch for setting a different code.
The lower button is a special button for parking the lift. On the backside is a red or
green cover. Green means the remote functions on radiofrequency (2,4 Ghz), red
means the remote functions on infrared.
Under this cover you can find a dipswitch to set a different canal.
The infrared remotes work out of the box. If they don’t, they can be linked as follows:
Press and hold the red button on the board P1. A yellow light will illuminate on the
board. Press any button on the handset and the light will go out.
