DEALER PRE-DELIVERY CHECK LIST
AFTER COMPLETION, DEALER SHOULD REMOVE AND RETAIN FOR RECORDS
After the Roller Mixer has been completely set-up, check to be certain it is in correct operating order
before delivering to the customer. The following is a list of points to inspect. Check off each item as you
have made the proper adjustments and found the item operating satisfactorily.
Mixer was not damaged in shipment. Check for dents and loose or missing parts. Report
damage immediately to H&S Manufacturing Co., Inc.
All bolts and fasteners are tight.
Mixer has been correctly assembled according to instructions in this manual. Wheels are
properly mounted and wheel nuts are torqued to specs.
Check all bearing locking collars to ensure they are tight on the shafts and in good condition.
Check that all set screws on the bearing collars are tight.
Check that all bearing mounting hardware is secure.
All grease fittings have been lubricated. The transmission and cyclonic reservoir are filled to
proper levels. See Lubrication Chapter of this manual for details.
No visible leaks on the hydraulic pump, motors, hoses and fittings.
Guards and shields are secure.
Tires are inflated to 80 PSI (563 kpa).
Belts are properly adjusted.
Discharge auger door operates smoothly.
Decals are in place and legible.
Lights and wiring functioning properly if applicable.
Connect the Mixer onto a proper horsepower 540 RPM or 1000 RPM (if applicable) tractor
and attach the PTO. Connect the scale and lights if applicable. Run the Mixer and make
sure all components operate properly.
PTO guard turns freely.
Hydraulic system does not leak under pressure.
Electronic Scale (if provided) operates properly.
Implement and all components are functioning properly.
-5-
(Remove Dealer File Copy
At Perforation)
INTAKE AUGER (If applicable)
Guards, shields, and attaching hardware are in place and properly secured.
Intake Auger supporting mechanisms function correctly.
Safety locking clip is in place & locked.
Hydraulic motor and speed control levers operate properly during operation.
Decals are in place and legible.
Serial Number
Dealer’s Name
Signature of Pre-Delivery Inspector
Model Number
Inspection Date
Summary of Contents for 9117
