-23-
LUBRICATION
GENERAL INFORMATION
If lubricated properly and often enough, it will prolong the life of your Industrial Chassis. Grease daily during
normal use and
before and after storage and after power washing.
Use a good grade of Lithium-based
grease. Make sure that grease comes out around the shaft on sleeve type bearings. Wipe off excessive
grease to prevent accumulation of chaff or grit around bearing.
Become familiar with all lubrication points and establish a routine to ensure complete
lubrication of the Chassis.
IMPORTANT:
Catch and dispose of fluid per local waste disposal regulations whenever service is performed
on hydraulic components, valves, cylinders, hoses, etc.
Wheel Hub Zerk
(1 on each wheel hub)
Walking Beam
Pivot Zerk
(1 on each Pivot)
(1) Jack Zerk
Summary of Contents for CH3130
