Installation instructions
Pass the wire through the hole
in the base and connect with
a flathead screw driver. As
illustrated. Fix the plug cable to
the back of the backplate by the
cable clamp
Drill four 7mm holes in the wall to
a depth of 40mm. Insert the raw
plugs into the holes and secure the
unit on the wall with the screws.
The back plate has a hook that the
machine cover will hang onto. Place
the machine cover above it and
allow it to slot onto the hook.
Insert the screws into the holes to
secure the unit.
Remove the two screws on the
bottom of the panel with the allen
key, remove the outer shell.
