Easy Braille
Start-Up
Handy Tech
Elektronik GmbH
Page 14
However, there is no actual conversion from 8-dot to 6-dot Braille code, but
this is unnecessary for most characters.
Entering [3] once again toggles the display back to 8-dot representation.
The following message will appear on the Braille modules:
'
6-BRAILLE/8-BRAILLE'
Depending on the current setting, this message will appear in either 6-dot
or 8-dot Braille. The default setting is 8-dot representation.
[2]
Energy saving mode on/off
If energy saving mode is on, the Braille system is turned off after a certain
period of inactivity. The following messages will appear on the Braille
display:
'energy-saving mode on'
'energy-saving mode off'
[1]
Set energy saving period
This option allows you to specify the time period after which your Easy
Braille should switch into energy saving mode. The message
'default
time: xxx min'
will appear on the display, where xxx indicates the number
of minutes before energy saving mode is turned on. By pressing the [1] key
again, you can increase this setting in increments of three minutes. If a
value of higher than 120 is entered a period of 3 minutes will automatically
be set.
[L]
Select message language
The text messages can be output in either German or English. By pressing
the [L] key, you may select the language. The following messages will
appear on the Braille display:
’Sprache: deutsch’
’language: english’
The settings go into effect as soon as they have been entered.
[R]
Select number representation in start-up message and in configuration
mode
The following message will appear:
'number presentation: 01'
where 01 is displayed from the ISO character set, i.e., numbers with Dot 6.
'number presentation: 02'
where 02 is displayed in US English Braille, i.e., the letters a through j
transposed down by one row.
'number presentation: 03'
where 03 is displayed in the Norwegian number representation, i.e. the
letters a through j with Dot 8.
[4]
Signal tone on/off (only Bluetooth devices)
This key can be used to switch the low-battery signal tone in Bluetooth
mode on and off. The possible settings are:
’low battery warning on’
’low battery warning off’
