52
10
11
Use 1/8-unch and 7/64-inch drill bits to drill a hole in the marked location.
Mark the engine dome in the location shown for throttle rod then remove the
engine.
Prepare the throttle rod by installing the clevis and ball link. Measure 98mm
between ball link and clevis and using a felt pen and mark the end of the
clevis on the threaded rod. This is an approximate length and may need
adjusting depending of the location of the servo tray. Remove the clevis.
12
throttle serVo installation • • •
Summary of Contents for Composite QQ Yak-54 2.6m
Page 99: ...99 ...
