39
Required Parts
• Hatch
• Canopy
• 4-40 x 1/2" screw (4) • #4 washer (4)
• Decals
• 25–30% pilot
Required Tools and Adhesives
• Hex wrench: 3/32"
• Formula 560-canopy glue
• Shoo Goo
• Masking tape
Step 1
Cut out the instrument panel decal from the decal
sheet. Attach it into position.
Step 2
Install a 25% or 30% pilot figure to the hatch using
Shoo Goo or similar adhesive that will remain
flexible. Let the glue dry before securing the canopy
in place.
Step 3
Position the canopy onto the canopy hatch. Trace
around the canopy and onto the hatch using a
felt-tipped pen.
Step 4
Lightly sand the inside edge of the canopy and
slightly inside the line drawn on the hatch using
medium sandpaper.
Step 5
Apply a bead of RCZ56 Canopy Glue (ZINJ5007)
around the inside edge of the canopy. Position the
canopy onto the hatch. Use tape to hold the canopy
secure until the glue fully cures.
Step 6
Apply the decals using the photos on the box
as a guide.
Section 13 – Hatch Assembly