15
Step 4
Mix a small amount of 12-minute epoxy. Apply epoxy to
the portion of the flap stay that is inserted into the wing.
Also apply epoxy inside the slot in the wing.
Step 5
Use a piece of masking tape to hold the flap stay in
position while the epoxy cures. Remove any excess epoxy
using a paper towel and rubbing alcohol.
Step 6
Locate a 4
3
/
4
-inch (121mm) pushrod wire, clevis and
clevis retainer. Slide the retainer onto the small end of the
clevis. Thread the clevis onto the linkage wire until the
wire is barely visible between the forks of the clevis.
Section 2: Fixed Flap Installation