27
Step 4
Use drill and a 1/8-inch (3mm) drill bit to drill the holes
for the cowling mounting screws. Remove the clear
cowling and use hobby scissors to trim the painted
cowling. Use a rotary tool and sanding drum to clean up
any jagged edges. Remember to make the cut behind the
engine head (can be seen in Step 5) so the cowling can be
opened to fit over the engine.
Step 5
Slide the cowling in position on the fuselage.
Note
: Two spinners have been included with
your F-22 Raptor. Use the 3-blade spinner
for trainer use and lower flight speeds
with the 3-blade Trainer Power System
propeller (EVOE100P). The 2-blade spinner
is preferred for 2-blade props, sport flying
and for higher speeds. Installation of either
spinner follows the same procedure.
Step 6
Slide the spinner backplate onto the engine shaft
Step 7
Slide the propeller onto the engine shaft.
Section 5: Cowling Installation
