44
Ailerons
Check to make sure the clevis is located in the outer hole
of the control horn. If not, slide the clevis retainer forward,
disconnect the clevis, connect it in the correct location,
and slide the clevis retainer back into position.
Make sure the aileron servo leads are connected as
described in the previous section. Center the aileron trim
on the transmitter.
Turn on the transmitter, then the receiver. Thread the clevis
as necessary until the aileron is even with the wing tip.
Note
: Align the aileron with the wing
tip as shown if you are not installing the
NACA droops on your F-22 Raptor.
Elevator
Connect the elevator clevis to the elevator control horn.
Section 11: Centering the Control Surfaces